2
Safety caution
Please read the manual carefully before using. Make sure your operation is correct and safety. The
following contents are only aimed at MP series products.
Please keep the manual properly, put in the location easy to get and read, hand the manual to the
end users.
Please do not bundle power line with communication cable or let them too close,
keep at least 10cm.
Please do not install module or change the wire. Otherwise it may cause
malfunction, error action, damage or fire.
Please shut off the power when there is abnormal smell or voice in MP products.
(The short sound made by buzzer after power on is normal)
Do not strike the HMI with a hard or sharp object, or press on the touch panel with
too much force or with pen, screw, since it may damage the HMI and cause
damage.
Please tighten the screws when install the products to prevent from falling off.
Please transport, store, set up, install and maintain the products correctly, otherwise
the HMI may be damaged.
Confirm the rated voltage of MP and connect correct before power on.
Please do not touch the terminals after power on to avoid electric shock.
Please do not open the cover board.
Please cut off all the power when installing or disassembling the products, or it
may cause error action and malfunction.
Please use MP series HMI in suitable environment conditions according to
instructions, otherwise it may cause accident.
Please do not use the products where there is high frequency radiate, high magnetic
field or other interferences.
To Next Page
Need help?
General