REGULAR MEMORY
Yaesu FT-8800R Operating Manual (courtesy of W5JCK) Page 38 of 83
Store Independent Transmit Frequencies
To store independent transmit frequencies (odd splits) in a memory channel:
1. Store the receiving frequency using the instructions described in Store a Frequency
in Memory on page 36.
2. Turn to the desired transmit frequency on the Main band, then press and hold in the
SET key for ½ second.
3. Within ten seconds of pressing the SET key, use the DIAL knob or
microphone’s and buttons to select the same memory channel number as
used in step 1 above.
4. Press and hold in the PTT switch, then press the SET key momentarily while
holding the PTT switch to save the entry and exit to normal operation. (This will not
cause transmission; instead, it signals the microprocessor that a separate transmit
frequency is being programmed into that memory register.) 0.
Whenever you recall a memory which contains independently-stored
transmit and receive frequencies, the (odd split) indicator will be
displayed.
Recall a Stored Memory
To recall (activate) a stored memory channel:
1. If operating in the VFO mode, press the key momentarily to enter the Memory
mode.
2. Rotate the DIAL knob to select the desired channel. 0.
When the radio is already set to the Memory mode, an easy way to recall
memories is enter the three-digit memory channel number from the
MH−48A6J microphone's keypad. For example, to recall memory channel
#4, press 0 0 4.
To Next Page
Loading...
Need help?
General
