Page 140 FTDX5000 OPERATING MANUAL
I
NSTALLATION
OF
THE
O
PTIONAL
R
OOFING
F
ILTER
(
XF-126CN
)
1. Turn the front panel
[
POWER
]
switch “off,” then turn
the rear panel’s
[
POWER
]
switch “off.”
2. Disconnect all the cables from the transceiver.
3. Referring to Figure 1, remove the three screws from
each side of the transceiver and four screws from the
top of the transceiver, then remove the top cover.
4. Refer to Figure 2, there is the metal plate on the right
side of the transceiver. A mounting position of the op-
tional filter is inside of this. Remove the three screws
affixing the metal plate, then remove the metal plate.
5. Refer to Figure 3, position the filter so that its connec-
tors are aligned with the mounting pins on the board,
and push it into place.
6. Replace the metal plate and its three screws.
7. Replace the top cover and its ten screws.
8. Filter installation is now complete.
9. Connect the all cables to the transceiver.
FIGURE 1
FIGURE 2
Ê
Ì
É
Ë
ÊÉ
È
FIGURE 3
To Next Page
Loading...
Need help?
General
