VR-500 OPERATING MANUAL16
PRESET MODE
Operation of the VR-500 can be greatly simplified by utilizing the “PRESET” mode. The
PRESET mode provides ten “starting point” frequencies (one frequency in each of ten
popular listening bands), from which you may then begin manual tuning.
To operate in the PRESET mode:
•
Press the [CLR(P.SET)] key (momentarily) while pressing the [FUNC] key to change
the VR-500 operating mode to PRESET.
‚
Now just press one of the numbered keys on the keypad to recall the Pre-Programmed
Frequency corresponding to that key, as shown below.
Basic Operation
1
2
3
4
5
6
7
8
9
•
0
0.5200 MHz (AM)
3.5000 MHz (LSB)
7.0000 MHz (LSB)
14.0000 MHz (USB)
50.0000 MHz (CW)
88.0000 MHz (WFM)
144.0000 MHz (CW)
430.0000 MHz (NFM)
1240.0000 MHz (NFM)
Weather Channel
This is a special “PRESET” key which toggles
through the Pre-Programmed Frequencies,
per the following selections:
Channel
Number
Pre-Programmable Frequency
ƒ
Once you have chosen a PRESET band segment, you can move off of the Pre-Pro-
grammed Frequency by rotating the DIAL knob. However, you cannot perform direct
frequency entry, as each keystroke will select a new Pre-Programmed band segment.
„
Press the [CLR(P.SET)] key again, while pressing the [FUNC] key, to disable the
PRESET mode and return to normal operation.
To Next Page
Loading...
Need help?
General
