EasyManuals Logo
Home>Yaesu>Receiver>VR-500

Yaesu VR-500 User Manual

Yaesu VR-500
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
VR-500 OPERATING MANUAL 19
Press [2 ABC] to enter “A” as the next character. Rotate the DIAL one click clock-
wise while holding in the [FUNC] key to move on to the next character.
Press [2 ABC] to enter “A” as the next character. Now rotate the DIAL two clicks
clockwise while holding in the [FUNC] key to insert a space and to move on to the
next character.
We now need to change from letters to numbers, so release the [FUNC] key, and
then rotate the DIAL one click so that “123” appears in the upper right-hand
corner of the display.
Press the [4 GHI] key to enter “4” as the next character. Rotate the DIAL one click
clockwise while holding in the [FUNC] key to move on to the next character.
Press the [5 JKL] key to enter “5” as the next character. Rotate the DIAL one click
clockwise while holding in the [FUNC] key to move on to the next character.
Press the [0] key to enter “0” as the final digit of the alpha-numeric label.
Press [ENT (SET/NAME)] to save the alpha-numeric information.
Finally, press and hold in the [FUNC] key; while holding it in, press [0] è [1] è
[0]. The display will indicate “010 Write!” momentarily, after which the display
will revert to 162.450 MHz, which is the current VFO frequency.
You still are operating in the VFO mode, and you may store other channel frequencies into
other memory channel registers in the same manner. To recall these memories, proceed to
the next section.
MEMORY RECALL
Recall of memorized channels is very simple:
Press the [1(MEMO)] key momentarily while pressing the
[FUNC] key. You may now release the [FUNC] key. “MR
will appear in the bottom left-hand corner of the display, indi-
cating that you are now operating in the Memory Recall mode.
Rotate the DIAL knob to select the desired memory channel, or enter the desired three-
digit memory channel number from the keypad.
To return to the VFO mode from the Memory mode, just press the [CLR (P.SET)] key.
VFO” will appear in the bottom left-hand corner of the display.
Memory Mode

Other manuals for Yaesu VR-500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yaesu VR-500 and is the answer not in the manual?

Yaesu VR-500 Specifications

General IconGeneral
BrandYaesu
ModelVR-500
CategoryReceiver
LanguageEnglish

Related product manuals