VR-500 OPERATING MANUAL 27
CLEARING OF A MEMORY BANK
This feature allows to mask (clear) the all memory channels in the desired memory bank at
the same time.
•
Set the radio to the VFO mode by pressing the [CLR(P.SET)] key.
‚
Press the [ENT(SET)] key while pressing the [FUNC] key to activate the “Set” (Menu)
mode.
ƒ
Rotate the DIAL knob to select Menu #26 [Clear Bank].
„
Rotate the DIAL knob one click clockwise while pressing the
[FUNC] key to enable the setup of Memory Bank Clearing.
…
Key in the memory bank number (one digit) to be cleared
from the keypad.
†
The display will now indicate “Clear ...” for about four seconds. Thereafter, clearing
of the prescribed Memory Bank will be complete.
‡
Press the [CLR(P.SET)] key to exit to normal operation.
Important Note: A cleared Memory Bank can not be restored. All data for that bank will
have to be re-entered.
MEMORY CHANNEL CHECK
This feature allows you to view the number of Vacant Memory Channels in the each Memory
Bank (or all Memories).
•
Set the radio to the VFO mode by pressing the [CLR(P.SET)] key.
‚
Press the [ENT(SET)] key while pressing the [FUNC] key to activate the “Set” (Menu)
mode.
ƒ
Rotate the DIAL knob to select Menu #29 [Vacant Memory].
„
Rotate the DIAL knob while pressing the [FUNC] key to re-
view the number of Vacant Memory Channels in the each
Memory Bank. The total number of available Memory Chan-
nels will also be displayed after the display of Bank #9's available space.
…
Press the [CLR(P.SET)] key to exit to normal operation.
Memory Mode
To Next Page
Loading...
Need help?
General
