Instrument and control functions
6-20
6
EAUM2852
Auxiliary DC jack
EWA14361
To prevent electrical shock or short-
circuiting, make sure that the cap is
installed when the auxiliary DC jack
is not being used.
ECA15432
The accessory connected to the
auxiliary DC jack should not be used
with the engine turned off, and the
load must never exceed 12 W (1A),
otherwise the fuse may blow or the
battery may discharge.
This vehicle is equipped with an auxil-
iary DC jack in the front storage com-
partment.
A 12-V accessory connected to the
auxiliary jack can be used when the
main switch is on and should only be
used when the engine is running.
To use the auxiliary DC jack
1. Open the front storage compart-
ment lid. (See page 6-16.)
2. Turn the main switch off.
3. Remove the auxiliary DC jack cap.
4. Turn the accessory off.
5. Insert the accessory plug into the
auxiliary DC jack.
6. Turn the main switch on, and then
start the engine. (See page 8-1.)
7. Turn the accessory on.
1. Auxiliary DC jack cap
1. Auxiliary DC jack
1
UBF6EYE0.book Page 20 Friday, July 14, 2017 3:39 PM
To Next Page
Loading...
Need help?
General