4-3
4
If the warning light stays on, allow the engine to
cool. If the warning light stays on when the engine
is cool, have a Yamaha dealer check the electrical
circuit.
CAUTION:
ECB00010
● The engine may overheat if the ATV is over-
loaded. In this case, reduce the load to spec-
ification.
● Start the engine after making sure that the
warning light is out. Continuous use while
the warning light is on may cause damage to
the engine.
EBU17952
On-Command four-wheel-drive indicator light
“”
This indicator light comes on when the On-Com-
mand four-wheel-drive switch is set to the “4WD”
position.
NOTE:
Due to the synchronizing mechanism in the differ-
ential gear case, the light may not come on until
the ATV starts moving.
EBU28341
On-Command differential gear lock indicator
light “”
This indicator light and the On-Command four-
wheel-drive indicator light “” come on when the
On-Command differential gear lock switch is set to
the “LOCK” position.
EBU18020
Speedometer
The speedometer shows the riding speed. This
speedometer is equipped with an odometer and a
tripmeter. The tripmeter can be reset to “0” with the
reset knob. Use the tripmeter to estimate how far
you can ride on a tank of fuel before going to re-
serve. This information will enable you to plan fuel
stops in the future.
U4S110E0.book Page 3 Friday, August 4, 2006 4:03 PM
To Next Page
Loading...
