4-14
4
EBU18560
Shift pedal
This ATV is equipped with a constant-mesh 5-
speed forward and 1-speed reverse transmission.
The shift pedal is located on the left side of the en-
gine. Reverse is at the bottom position and neutral
is one position above reverse.
EBU18641
Reverse knob “REV”
The reverse knob is used to shift into reverse. See
the “Operating the reverse knob and driving in re-
verse” section on page 6-3 before operating this
ATV in reverse.
WHAT CAN HAPPEN
The ATV could start moving unexpectedly if
the parking brake is not applied before start-
ing the engine. This could cause loss of con-
trol or a collision.
The brake could overheat if you ride the ATV
without releasing the parking brake. You
could lose braking performance which could
cause an accident. You could also wear out
the brakes prematurely.
HOW TO AVOID THE HAZARD
Always set the parking brake before starting
the engine.
Always be sure you have released the park-
ing brake before you begin to ride.
1. Shift pedal
U4S110E0.book Page 14 Friday, August 4, 2006 4:03 PM
To Next Page
Loading...
Need help?
General
