Operation
43
turns smoothly and that it completely re-
turns to the fully closed position.
Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and
unrestricted throughout the whole range
with no binding or excessive free play.
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
Look for loose or damaged connections of
the throttle and shift cables.
EMU36484
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU40994
Engine oil
1. Place the outboard motor in a vertical
position (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
2. Remove the oil dipstick and wipe it
clean.
3. Insert the oil dipstick completely and re-
move it again.
4. Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil
level is not at the proper level or if it ap-
1. Cord
2. Clip
3. Engine shut-off switch
1. Cord
2. Clip
3. Engine shut-off switch
1. Oil dipstick
6AG-9-3D-1E0.book 43 ページ ２０１５年１１月５日 木曜日 午前１１時７分
To Next Page
Loading...
Need help?
General
