Operation
49
firm. During engine operation, place the
tank horizontally, otherwise fuel cannot
be drawn from the fuel tank.
When using the fuel tank on the boat, a
fuel valve may also be equipped on the
boat. Open the fuel valve.
Check the boat’s manual for the position of
the fuel valve.
EMU27495
Starting engine
EWM01601
Before starting the engine, make sure
that the boat is tightly moored and that
you can steer clear of any obstructions.
Be sure there are no swimmers in the wa-
ter near you.
EMU39014
Manual start/prime start models
EWM01842
Failure to attach the engine shut-off
cord could result in a runaway boat if
operator is ejected. Attach the engine
shut-off cord to a secure place on your
clothing, or your arm or leg while oper-
ating. Do not attach the cord to clothing
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
Starting procedure (cold engine)
1. Place the gear shift lever in neutral.
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
1. Arrow
2. Primer pump
6AG-9-3D-1E0.book 49 ページ ２０１５年１１月５日 木曜日 午前１１時７分
To Next Page
Loading...
Need help?
General
