Operation
36
EMU27153
Engine
●
Check the engine and engine mounting.
●
Look for loose or damaged fasteners.
●
Check the propeller for damage.
●
Check for engine oil leaks.
EMU36490
Flushing device
Check that flushing device’s garden hose
connector is securely screwed on to the fit-
ting on the bottom cowling.
NOTICE:
If the
flushing device is not properly connect-
ed, cooling water can leak out and the en-
gine can overheat during operation.
[ECM01800]
EMU36953
Install cowling
1. Be sure that a cowling lock lever is re-
leased.
2. Be sure that the rubber seal is seated all
the way around the top cowling.
3. Place the top cowling on bottom cowl-
ing.
4. Check to be sure the rubber seal fits cor-
rectly all the way around the engine.
5. Move the lever to lock the cowling as
shown.
NOTICE:
If the cowling is not
installed correctly, water spray under
the cowling can damage the engine,
or the cowling can blow off at high
speeds.
[ECM01990]
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
top cowling is loose, have it repaired by your
Yamaha dealer.
EMU34782
Checking power tilt system
WARNING
EWM01970
●
Never get under the lower unit while it
is tilted, even when the tilt support
knob is locked. Severe injury could oc-
cur if the outboard motor accidentally
falls.
●
Body parts can be crushed between the
motor and the clamp bracket when the
motor is trimmed or tilted.
●
Be sure no one is near the outboard
motor before performing this check.
1. Check the power tilt unit for any sign of
1. Fitting
2. Flushing device
ZMU06172
2
1
ZMU06136
To Next Page
Loading...
Need help?
General
