Trouble Recovery
83
6. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope 1 or 2 turn(s)
around the flywheel clockwise.
7. Pull the rope slowly until resistance is
felt. Give a strong pull straight out to
crank and start the engine. If the engine
does not start on the first try, repeat the
procedure.
IP:
●
If the engine does not start on the first try,
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount (between 1/8 and 1/4) and
try again. Also if the engine is warm and
fails to start, open the throttle a same
amount and try to start the engine again. If
the engine still fails to start, see page 39.
●
Slowly return the throttle grip to the fully
closed position so that the engine does not
stall.
EMU32003
Emergency starting engine (electric
start model)
1. Remove the top cowling.
2. Remove the dust cover.
3. Remove the electrical system cover by
removing its screw(s).
4. Remove the screw(s) from the plate,
and pull it down.
ZMU05533
N
ZMU02026
ZMU05610
ZMU05611
ZMU05612
To Next Page
Loading...
Need help?
General
