Maintenance
70
7. Leave the outboard motor for 5-10 min-
utes.
8. Remove oil dipstick and wipe it clean.
9. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
10. Recheck the oil level using the dipstick
to be sure the level falls between the up-
per and lower marks. Consult your
Yamaha dealer if the oil level is out of
specified level.
11. Start the engine and make sure that the
low oil pressure-alert indicator remains
off. Also, make sure that there are no oil
leaks.
NOTICE:
If the low oil pressure-
alert indicator comes on or if there
are oil leaks, stop the engine and find
the cause. Continued operation with
a problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01622]
12. Dispose of used oil according to local
regulations.
IP:
●
For more information on the disposal of
used oil, consult your Yamaha dealer.
●
Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
EMU29113
Checking wiring and connectors
●
Check that each connector is engaged se-
curely.
●
Check that each ground lead is properly
secured.
1. Oil filler cap
Recommended engine oil:
4-stroke outboard motor oil
Total engine oil quantity (oil pan capaci-
ty):
Without oil filter replacement:
1.6 L (1.69 US qt, 1.41 Imp.qt)
With oil filter replacement:
1.8 L (1.90 US qt, 1.58 Imp.qt)
ZMU05562
1
1. Lower level mark
2. Oil dipstick
3. Upper level mark
ZMU02082
1
3
2
To Next Page
Loading...
Need help?
General
