5-84
E
POWR
CONNECTING RODS AND PISTONS
• If out of specification, replace the piston
and piston rings as a set.
• Calculate the piston-to-cylinder clearance
with the following formula.
Piston-to-cylinder clearance = Cylinder
bore “C” – Piston skirt diameter “P”
Piston-to-cylinder clearance:
0.10–0.11 mm (0.0039–0.0043 in)
<Limit>: 0.17 mm (0.0067 in)
• If out of specification, replace the piston
and piston rings as a set.
Piston ring inspection
1. Measure:
• Piston ring side clearance
Out of specification
→
Replace the pis-
ton and piston rings as a set.
NOTE:
Before measuring the piston ring side clear-
ance, eliminate any carbon deposits from the
piston ring grooves and piston rings.
Side clearance:
Top ring:
0.030–0.065 mm
(0.0012–0.0026 in)
2nd ring:
0.020–0.055 mm
(0.0008–0.0022 in)
Oil ring:
0.040–0.160 mm
(0.0016–0.0063 in)
To Next Page
Loading...
Need help?
General