7-17
E
– +
ELEC
NOTE:
To crank the engine, connect the engine shut-
off cord (lanyard) to the engine shut-off switch,
and then press the start switch and engine
stop switch simultaneously.
4. Measure:
• Rectifier/regulator output voltage
Below specification
→
Replace the recti-
fier/regulator.
NOTE:
• Do not use the peak voltage adapter to mea-
sure the output voltage.
• Disconnect the output lead of the tester har-
ness.
Test harness (6 pins):
YB-06848
Test harness FSW-6A (6 pins):
90890-06848
Rectifier/regulator output
voltage:
Red (R) – Black (B)
r/min
Unloaded
3,500
V 13.0
BATTERY
Refer to “ELECTRICAL” in Chapter 3.
FUSE
Refer to “STARTING SYSTEM”.
SPARK PLUGS
Refer to “POWER UNIT” in Chapter 3.
IGNITION SYSTEM
To Next Page
Loading...
Need help?
General