4-47
KICK AXLE, SHIFT SHAFT AND PRIMARY DRIVE GEAR
ENG
5. Install:
9
Crankcase cover (right) 1
NOTE:
Mesh the governor gear 2 with the governor
drive gear 3 and the impeller shaft gear 4 with
the primary drive gear 5.
4. Install:
9
Dowel pin 1
9
Gasket [crankcase cover (right)] 2
3. Tighten:
9
Bolt (primary drive gear) 1
NOTE:
Place an aluminum plate a between the teeth of
the primary drive gear 2 and driven gear 3.
EC4C5531
Primary drive gear
1. Install:
9
Thrust plate 1
9
Primary drive gear 2
9
Governor drive gear 3
9
Plain washer 4
9
Bolt (primary drive gear) 5
NOTE:
9
Install the plain washer with its chamfered side
a toward you.
9
Temporarily tighten the bolt at this point.
2. Install:
9
Primary driven gear
Refer to “CLUTCH AND PRIMARY DRI-
VEN GEAR” section.
55 Nm (5.5 m•kg, 40 ft•lb)
1P8-9-30-4B 11/5/04 10:59 AM Page 40
To Next Page
Loading...
Need help?
General
