Yealink SIP-T41P Configuration Guide

Yealink IP Phones Configuring Guide
2
To connect the PoE:
1. Connect the Ethernet cable between the Internet port on the phone and an
available port on the in-line power switch/hub.
Note
After your phone is powered on, the phone boots up and attempts to contact a DHCP
server in your network to obtain valid IPv4 network settings (e.g., IP address, subnet
mask, default gateway address and DNS address) by default.
You can view phone status via phone user interface.
Available information of phone status includes:
 Network status (e.g., IPv4 status, IP mode, MAC address).
 Phone status (e.g., product name, hardware version, firmware version, product ID,
MAC address and device certificate status).
 Account status (e.g., register status of SIP accounts).
To view the phone status via phone user interface:
1. Press , or press Menu->Status.
If in-line power switch/hub is provided, you don’t need to connect the phone to the power
adapter. Make sure the switch/hub is PoE-compliant.
The IP phone can also share the network with another network device such as a PC
(personal computer). It is an optional connection.
Important! Do not unplug or remove the power while the IP phone is updating firmware
and configurations.

Yealink SIP-T41P Specifications

General

Power requirements	AC 100-240V, DC 5V
Power over Ethernet (PoE)	Yes
Touchscreen	-
Display diagonal	2.7 \
Display resolution	192 x 64 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	3
Voice codecs	G.711, G.723, G.726, G.729A, G.729B
Bluetooth	No
Ethernet LAN (RJ-45) ports	2
Storage temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	189 mm
Width	212 mm
Height	175 mm