EasyManuals Logo
Home>Zebra>Barcode Reader>DS4308

Zebra DS4308 Product Reference Guide

Zebra DS4308
520 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #337 background imageLoading...
Page #337 background image
Intelligent Document Capture 12 - 17
Quick Start
This section familiarizes you with some of the Intelligent Document Capture features. IDC Demonstrations on
page 12-18 includes instructions to demonstrate the Anchored, Free-Form, and Linked modes using a sample
form to help provide an understanding of how to use IDC. These examples do not illustrate all capabilities of
the advanced IDC firmware. Build upon these using different parameter settings and forms.
Sample IDC Setup
To set up IDC with the decoder:
1. Connect a decoder equipped with the Intelligent Document Capture feature to the host computer's USB
port.
2. To set the decoder to the default settings and proper USB host type, scan Set Defaults followed by the
Symbol Native API (SNAPI) with Imaging Interface bar code. Allow time for the decoder to reset and the
USB connection to remunerate after each scan before continuing.
3. Start the sample application and select the decoder in the SNAPI Scanners drop-down menu.
4. Set the parameters as specified in IDC Demonstrations on page 12-18 using the sample application or by
scanning parameter bar codes in this guide. The bar code in the sample form is Code 128, which is
enabled by default for decoding and as a Document Capture symbology. You can change these settings
for your IDC application.
5. Perform the list of suggestions in each demo. When scanning, aim the engine at the bar code in the center
of the rectangle. Pull the engine back so the rectangle is fully contained in the aiming pattern. When you
pull the trigger, the decoder emits a low tone to indicate that the IDC firmware identified and captured an
image, then a decode beep to indicate that the data is processed and transmitted. There may be several
seconds between the two beeps, depending on the size of the captured image and options selected
(de-skew, brighten, etc). You can move the decoder after the first beep, but continue the hold the trigger or
the decoder may end the session before sending the data.
Set Defaults
Symbol Native API (SNAPI) with Imaging Interface

Table of Contents

Other manuals for Zebra DS4308

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra DS4308 and is the answer not in the manual?

Zebra DS4308 Specifications

General IconGeneral
BrandZebra
ModelDS4308
CategoryBarcode Reader
LanguageEnglish

Related product manuals