149
MAINTENANCE INSTRUCTIONS
E704 E705
REPLACEMENT OF FULL-FLOW
ENGINE OIL CLEANER
It is replaced with each replacement of
engine oil. Before re-installation of a new
cleaner clean the sealing surface of the
body (1) and cleaner (2). Apply engine
oil on rubber sealing and tighten the
cleaner by hand. After seating of the
sealing onto sealing of the block tighten
the cleaner by additional 3/4 to 1 1/4
turn. Check tightness after start of the
engine.
POURING OF OIL INTO ENGINE
Pour prescribed volume of oil into the fill-
ing hole (2, start the engine and let it
running for 2 to 3 minutes at 750 to 800
rpm.
After stopping the engine and stabilisa-
tion of level check oil level using the oil
gauge rod (1) and check tightness of the
cleaner, drain plug (3) and other connec-
tions.
To Next Page
Loading...
Need help?
General