Ziehm Imaging, Inc. VISION User Manual

MAN 06-0015: Rev. A Page 1
ZIEHM VISION INSTALLATION MANUALInstallation
Installation Manual
This Installation Manual supplements the ZIEHM VISION Service
Manual. By no means should installation be attempted without consult-
ing the Service Manual in addition to this Installation Manual.
AudienceThis manual is written to qualified Service Engineers. It does not con-
tain any procedures that can be performed by the System Users. Do
NOT allow System Users to perform any of the service tasks described
in this manual, or any tasks that are not described in the User Manual.
In order to be qualified to perform the Installation procedures described
in this manual, Service Engineers must attend formal training provided
by Instrumentarium Imaging Ziehm. Inc. (hereafter referred to as the
manufacturer).
Unpacking the
C-Arm
Shipping Container
The system is shipped on a single pallet and contains a mobile stand,
monitor cart, case assembly (unmounted), and the items listed in the
table below.
Carefully inspect the equipment for damage. If you find any damage,
immediately report it to the shipping carrier in the form of a damage
claim.
Unpacking
Unpacking of the x-ray system is to be carried out by authorized, quali-
fied personnel.
1. To avoid damage being caused to the equipment by condensation
resulting from temperature differences, make sure that all parts of
the equipment have reached room temperature before turning the
equipment on
2. Remove the outside of the shipping container and inspect.
Item Quantity
User Manual 2
Technical Manual
- C-arm Technical Data
- Approval Certificate
2
Foot Switch 1
Hand Switch 1
Connection Cable 1

Ziehm Imaging, Inc. VISION Specifications

General

Type	Mobile C-arm
Imaging Modality	Fluoroscopy
Monitor Size	19"
Power Requirements	100-240 VAC, 50/60 Hz
Image Processing	Real-time image processing algorithms
Applications	Orthopedics, trauma, pain management

Summary

Ziehm VISION Installation Guide

System Interconnect and AC Power Verification

Details on connecting system components and verifying AC power.

Ziehm VISION Maintenance Procedures

Safety Guidelines and Document Verification

Crucial safety guidelines, document verification, and image intensifier checks.

Switch Safety Cutoff Test

Tests the system's immediate radiation stop upon switch release.

Radiation Indicators and Fluoroscopy Time Checks

kV Value Verification Procedure

Tube Current Measurement Tests

Exposure Reproducibility Testing

Assesses dose consistency across multiple exposures.

Beam Quality Analysis

Assesses the quality of the X-ray beam, including half-value layer.

Exposure Time and Dose Rate Compliance Checks

Central X-Ray Beam Alignment and Testing

Guides on checking and aligning the central X-ray beam.

Tube Head Adjustment Procedures

Central Beam Alignment Adjustment

Collimation Verification Procedures

Verifies collimation adherence to regulatory standards.

Image Intensifier and Cassette Format Checks

Smallest Field Size Measurement