Ziehm Imaging, Inc. VISION User Manual

ZIEHM VISION INSTALLATION MANUAL: Mounting
Page 2 MAN 06-0015: Rev. A
3. Lower the unloading ramp into position.
4. The Monitor Cart is secured to the pallet by a bracket and four
bolts. Remove the bolts and carefully slide the Monitor Cart off the
pallet.
5. Remove the two straps that hold the monitors and take the monitors
off the pallet.
6. Remove all of the brackets from the pallet.
7. Loosen the Wig-Wag knob and straighten the C-Arm as shown in
Figure 2.1. This will keep the C-Arm from tipping over as it is
removed.
8. Remove the metal brackets that hold the C-Arm mobile stand to the
pallet. Take care not to scratch the mobile stand.
9. Lift the lever located in the center of the control panel (the hand
brake) and carefully move the mobile stand off the pallet and onto
the floor.
2-1: C-Arm in the Transport Position
Mounting Monitors The monitors are the only components that need to be mounted. They
are clearly marked Left and Right (as viewed from the front of the
monitor cart).
1. Remove the monitor’s rear panels.
2. Have a qualified person help you place the monitor assembly onto
the mobile cart’s mounting surface.

Ziehm Imaging, Inc. VISION Specifications

General

Brand	Ziehm Imaging, Inc.
Model	VISION
Category	Medical Equipment
Language	English