3
1.5.7 The pallet fork should be kept in appropriate distance to avoid the eccentric load:
1.5.8 When the cargo approaches the fork wall, it should be lowered in height as much as possible, the mast
leaned back to allow the driving of forklift:
1.5.9 To ensure safety, no persons are allowed to stand beneath and on the pallet fork for lifting:
1.5.10 When the cargo is lifted or lowered, the initial velocity should be not too fast:
1.5.11 When the mast tilts forward or backward to the limiting position or the pallet fork lifted to the maximum
height, the operating handle should be quickly returned to the middle position:
1.5.12 When the cargo is conveyed by a forklift, use of emergency braking should be avoided as much as
possible to prevent the cargo from being thrown out or personnel injury.
1.6 Charge of battery pack
1.6.1 When the battery pack is charged initially and added afterward, the provisions in the battery instructions
should be strictly observed:
1.6.2 When the forklift is in operation, the battery capacity on the instrument panel is less than 10% or the
voltage of any single battery lower than 1.70V, you must stop working with the forklift until the battery pack
has been charged or replaced:
1.6.3 When in charge, check always the gravity, liquid level and temperature of electrolyte solution.
1.7 The maximum allowable noise value of battery forklift shall not be greater than 80dB (A) and the test
method adopted as per JB/T3300.
To Next Page
Loading...
General