5 System Configuration
5.1 Storage Settings
Before you start:
To configure recording settings, make sure that you have the network storage device within the network or
the memory card inserted in your camera. IF the camera is interfaced with VIGIL Server, footage recorded by
the VIGIL Server will be stored on the VIGIL Server’s media drive.
CONFIGURING RECORDING SCHEDULE
Purpose:
There are two kinds of recording for the camera: manual recording and scheduled recording. In this section,
follow the instructions to configure scheduled recording. By default, files recorded via scheduled recording are
stored in the memory card (if supported) or on the network disk. If interfaced with a VIGIL Server, recorded
files will be stored in the VIGIL Server’s media drive.
Steps:
1. Enter the Record Schedule settings interface: Configuration > Storage > Schedule Settings > Record
Schedule
Figure 5-1 Recording Schedule Interface
2. Toggle the Enable checkbox to enable scheduled recording.
3. To set advanced settings, click to enter the advanced settings interface.
Figure 5-2 Record Parameters
Pre-record: The time you set to start recording before the scheduled time or event. For example, if an
alarm triggers recording at 10:00, and the pre-record time is set as 5 seconds, the camera starts to
record at 9:59:55.
The pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or not limited.
NOTE: The pre-record time changes according to the video bitrate.
To Next Page
Loading...
Need help?
General
