3xLogic VISIX S-Series User Manual

VISIX S-Series Network Camera | USER MANUAL v6.0
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
40
Configuring Recording Schedule for setting the recording schedule.
CONFIGURING VIDEO TAMPERING ALARM
Purpose:
The user can configure the camera to trigger an alarm when the lens is covered / obscured and also configure
certain alarm response actions when tampering is detected.
Steps:
1. Enter the Video Tampering settings interface: Configuration > Event > Basic Event > Video
Tampering
Figure 5-15 Tampering Alarm
2. Check Enable checkbox to enable the tampering detection.
3. Click tab to enter the arming schedule settings interface. The arming schedule
configuration is identical to configuring the arming schedule for motion detection. Refer to Section
5.2.1 Configuring Motion Detection.
4. Click tab to select the linkage method taken for tampering. Notify Surveillance
Center, Send Email and Trigger Alarm output are selectable. Refer to Section 5.2.1 Configuring
Motion Detection for more information on configuring linkage methods.
5. Click to save the settings.
CONFIGURING VIDEO LOSS
Steps:
1. Enter the Video Loss settings interface: Configuration > Event > Basic Event > Video Loss

3xLogic VISIX S-Series Specifications

General

Brand	3xLogic
Model	VISIX S-Series
Category	Security Camera
Language	English