ABB ACH580-PCR User Manual

ACH580 E-Clipse bypass and packaged drive user manual 225
Installation
Installation flow chart
The installation of Input Disconnect configurations for ACH580 drives follows the
outline below. The steps must be carried out in the order shown. At the right of each
step are references to the detailed information needed for the correct installation of
the unit.
Note: References in the middle column below are to the ACH580-01 Hardware
Manual (3AXD50000044839). References in the third column below are to this
manual.
For more details, refer to the ACH580-01 Hardware Manual (3AXD50000044839).
Task
Reference in ACH580-01
Hardware Manual
(3AXD50000044839)
Installation section
Additional References in the
ACH580-01 Hardware Manual
(3AXD50000044839), including:
PREPARE for
installation
Preparing for installation in
the ACH580-01 Hardware
Manual
(3AXD50000044839)
• Drive identification
• Suitable mounting/venting
Note: Some instructions in this
document vary, depending on the
drive’s frame size.
PREPARE the mounting
location
PREPARE the mounting
location
--
REMOVE the front cover REMOVE the front cover --
MOUNT the drive MOUNT the drive --
INSTALL wiring Wiring overview and Install
the wiring
Installing the wiring (ACH580-01
Hardware Manual
[3AXD50000044839]).
CHECK installation Check installation --
RE-INSTALL the cover Re-install cover --
APPLY power Apply power --
START-UP -- --

ABB ACH580-PCR Specifications

General

Brand	ABB
Model	ACH580-PCR
Category	DC Drives
Language	English