ACS/ACC/ACP 604/607 Drives ACx=ACX/ACC/ACP B-1
Appendix B – ACx 607 Dimensional Drawings
Drawings
The following pages contain dimension drawings, cable connection
drawings and an assembly drawing. The dimension drawings show
the ACS 607 outline and mounting dimensions and various
enclosure details. The cable connection drawings show the
locations of the input power and motor connection terminals and the
recommended arrangement for routing the cables as they enter the
enclosure. The assembly drawing shows the location of the optional
X2 or 2TB control terminal block and the locations of various option
modules.
Dimension Drawings
Refer to
ACS 607 Enclosure Size and Style
on page A-21 for
information explaining how to determine the applicable drawings for
a particular drive configuration.
The drawings show the location and dimensions of the IEC cable
gland plates. NEMA style R7, R8 and R9 frame size drives have
blank conduit plates installed over 8.9 x 12.6 inch rectangular
openings at the top and bottom of the enclosures. NEMA style drives
have 8 as the 20th character of the Type Code.
Connection Drawings
The applicable connection drawings are determined by drive frame
size and cabling direction. Drive frame sizes are listed in the table
Dimensions and Weights (ACx 607)
on page A-22. Cabling direction
is determined by the 21st character of the ACS 607 Type Code.
Refer to the table
ACx 604/607 Type Code
on page 1-2.
IEC units have cable gland plates installed in the top and/or bottom
of the enclosure according to the cabling direction specified by the
Type Code. NEMA style R7, R8 and R9 frame size units have blank
conduit plates installed over 8.9 x 12.6 inch rectangular openings at
the top and bottom regardless of the cabling direction specified.
Both IEC and NEMA style units have variations in terminal location
and orientation according to the cabling direction specified.
It is generally feasible to change the cabling direction in the field or
to install cabling in the direction opposite to the configured direction.
The following drawing package is effective from 10/5/1998.
To Next Page
Loading...
Need help?
General
