ABB aquamaster User Manual

Electronic Commercial Water Meter
AquaMaster™ 1 Introduction
2 IM/AM Issue 13
1 Introduction
AquaMaster
TM
is a range of high performance electromagnetic flowmeters for the measurement of
electrically conductive fluids and are normally supplied as factory configured, calibrated systems.
Warning.
 Installation and maintenance must be carried out only by suitably trained personnel.
 Read all relevant sections of this manual before selecting a location.
 The safety requirements of this equipment, any associated equipment and the local environment
must be taken into consideration during installation.
 Install and use this equipment in accordance with relevant national and local standards.
 Specific safety precautions apply to the use of the GSM engine which forms part of the
GSM-equipped version of this product. If the unit purchased has GSM-capability, read Appendix
A on page 50 before selecting a location.

ABB aquamaster Specifications

General

Type	Electromagnetic flowmeter
Power Supply	100 to 240 VAC, 24 VDC
Communication	HART, Modbus, Profibus
Ingress Protection	IP68
Temperature Range	-40°C to +70°C (-40 to +158 °F)
Applications	Water, wastewater
Lining material	rubber
Electrode material	Stainless steel, Hastelloy, Titanium
Protection Rating	IP67, IP68
Output Signals	4-20 mA, pulse, frequency
Storage Temperature	-40 to +70 °C (-40 to +158 °F)
Accuracy	±1 mm/s
Operating Temperature	-40°C to +60°C
Ambient Temperature	-40°C to +60°C