Installing the Gas Analyzer 91
Fidas24: Power Supply Line Connection to 115/230 V AC
115/230-V-AC-connection cable
A connecting cable is supplied for the 115/230 V AC power supply for
heating the detector and, if applicable, the heated sample gas connection
(length 5 m, cable cross-section 3 x 1.5 mm
2
) with a 4-pole socket
connector for the connection to the analyzer module.
2
3
N
PE
The illustration shows the pin side of the plug 30 in the analyzer module
(see page 66).
The ope
rating voltage of the detector heating is automatically detected
and switched. The set voltage can be identified through two LEDs on the
mains distribution card.
115/230 V AC Connection to an Analyzer Module
1 Attach the supplied 115/230-V-AC connecting cable with the 4-pole
socket connector to the power supply connection 30 of the analyzer
module and screw tight.
2 Connect the wires on the free end of the power cable to the power
supply.
To Next Page
Loading...
Need help?
General
