Safety 13
• The drive can be programmed to start up and begin to turn the motor (auto-
enable) immediately after an input voltage break or a fault reset.
Note:
• If an external source for start command is selected and it is ON, the drive could
start immediately after an input voltage break or fault reset.
Network security
This product is designed to be connected to and to communicate information and
data via a network interface. It is your sole responsibility to provide and continuously
ensure a secure connection between the product and your network or any other
network (as the case may be). You shall establish and maintain any appropriate
measures (such as but not limited to the installation of firewalls, application of
authentication measures, encryption of data, installation of anti-virus programs, etc)
to protect the product, the network, its system and the interface against any kind of
security breaches, unauthorized access, interference, intrusion, leakage and/or theft
of data or information. ABB Motion Ltd and its affiliates are not liable for damages
and/or losses related to such security breaches, any unauthorized access,
interference, intrusion, leakage and/or theft of data or information.
To Next Page
Loading...
Need help?
General
