Start-up 21
Start-up
What this chapter contains
This chapter describes software installation and the start-up procedure of the drive.
Safety
WARNING! Read the Safety instructions on the first pages of this manual
before performing any maintenance on the equipment. Ignoring the safety
instructions can cause injury or death.
Introduction
Before powering the MotiFlex e180 you must connect it to the PC using an Ethernet
cable and install the Mint WorkBench software on the PC. This includes a number of
applications and utilities to allow you to configure, tune and program the
MotiFlex e180. Mint WorkBench and other utilities can be downloaded from the
SupportMe pages of www.abbmotion.com.
Connect the MotiFlex e180 to the PC
Connect a CAT5e or CAT 6 Ethernet cable between the PC and the MotiFlex e180 E3
Ethernet port on the front panel. Do not connect the cable to the E1 or E2 ports on the
top of the drive.
NOTE! You cannot connect an ordinary office PC to the MotiFlex e180 without
first altering the PC's Ethernet adapter configuration. See Configure the PC
Ethernet adapter on page 22.
To Next Page
Loading...
Need help?
General
