Chapter 2 37
BIOS Setup Utility
The BIOS Setup Utility is a hardware configuration program built into your computer’s BIOS (Basic Input/
Output System).
Your computer is already properly configured and optimized, and you do not need to run this utility. However, if
you encounter configuration problems, you may need to run Setup. Please also refer to Chapter 4
Troubleshooting when problem arises.
To activate the BIOS Utility, press
m during POST (when “Press <F2> to enter Setup” message is prompted
on the bottom of screen).
Press m to enter setup. The default parameter of F12 Boot Menu is set to “disabled”. If you want to change
boot device without entering BIOS Setup Utility, please set the parameter to “enabled”.
Press <F12> during POST to enter multi-boot menu. In this menu, user can change boot device without
entering BIOS SETUP Utility.
PhoenixBIOS Setup Utility
CPU Type :
Genunie Intel (R) CPU
CPU Speed :
BIOS Version:
V1.10
VGA BIOS Ver
Intel V1256
Serial Number
xxxxxxxxxxxxxxxxxxxxxx
Asset Tag Number
N/A
Produce Name
TravelMate 4200
Manufacturer Name:
Acer
UUID:
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
F1 Help
Select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit
Select Menu Enter Select
Sub-Menu F10 Save and Exit
HDD Model Name :
HDD Serial Number :
22 Byte
32 Byte
16 Byte
16 Byte
32 Byte
1.66GHz
ATAPI Serial Number :
None
ATAPI Model Name :
None
Main Advanced Security Boot Exit
Information
System Utilities
Chapter 2
To Next Page
Loading...
Need help?
General