Machine Maintenance Procedures 3-63
CCD Module Removal 0
Prerequisite:
LCD Bezel Removal
1. Locate CCD module on LCD cover. (Figure 3-86)
Figure 3-86. CCD Module
2. Disconnect cable (B) from connector (C). (Figure 3-87)
Figure 3-87. CCD Cable
3. Remove foil tab (D) covering cable.
4. Remove module (A) from lower cover.
CCD Module Installation 0
1. Install module (A) on lower cover. (Figure 3-87)
2. Install foil tab (D) to cover CCD cable.
3. Connect cable (B) to board connector (C).