5
IVEDITI 1707 - 4880981_01
The VED_I AERMEC units are constructed
according to the recognised technical
have been designed and must be used for
accordance with their technical features.
Any contractual or extra-contractual liabi-
lity of the Company is excluded for injury/
damage to persons, animals or objects
maintenance errors or improper use. All
uses not expressly indicated in this ma-
nual are prohibited.
maintenance, and cleaning stages.
Do not use the unit as storage for
equipment or spare parts. Any use other
than that indicated in this manual is
prohibited as it can generate dangerous
ATTENTION: the electric and hydraulic
of the fan coils and their accessories
must only be performed by technicians
who have the technical-professional
-
systems and who can verify these fun-
-
Aermec will not be liable for damage due
Make sure the unit has not been dama-
using a damaged machine could be dan
-
gerous;
the support surface must withstand the
weight of the unit.
Note:
Always indicate the serial number for fu
-
ture reference and for any communica-
-
they are always available in case of neces
-
sity.
WARNINGS REGARDING SAFETY AND IN-
STALLATION STANDARDS
-
installer.
The unit must be installed to enable main
-
tenance and/or repairs.
Do not modify or tamper with the units,
manufacturer will not be liable for any
damage caused. The validity of the war-
ranty shall be void in the event of failure
-
-
RISKS.
-
danger that may arise when the installa-
The unit must be installed to facilitate
-
ATTENTION: the fan coil is connected
to the power supply and the hydraulic
who do not have the required technical
skills can lead to personal injury to the
operator or damage the unit and the sur-
rounding environment.
ATTENTION: the unit must be installed
ATTENTION: make sure that the po-
wer supply has been disconnected before
ATTENTION: install a device, master
switch or electric plug that allows the
unit’s power supply to be completely di-
sconnected.
ATTENTION: In order to protect the
unit against short circuits, mount a ma
-
gnet circuit breaker omnipolar switch on
the power supply line. In order to avoid
any danger due to the accidental rear
-
ming of the thermal cut-out device, this
appliance must not be powered with an
or be connected to a circuit that is regu
-
larly powered or disconnected from the
service.
ATTENTION! DANGER! Any use other
than what is indicated by Aermec is prohi-
bited.
Supply the fan coil only with the volta-
ge value indicated in the data plate
The fan coil may be permanently dama-
used.
GENERAL WARNINGS
To Next Page
Loading...
Need help?
General
