1-7
Installing the 86100C
Step 3. Install the modules
Step 3. Install the modules
Up to two modules can be inserted into the Infiniium DCA. All documentation
(including specifications) for plug-in modules is located in the 86100C’s Help
system. To access the Help system, complete the installation steps, turn on
the 86100C, and click Contents on the Help menu.
NOTE You can safely insert and remove modules from the mainframe while the
86100C is powered on; this is known as hot swapping (also known as hot
plugging) and it greatly reduces the time required to change modules for
different measurement needs.
1 Slide the module into an available front-panel slot.
You can remove or install a module while the instrument is operating.
2 Finger tighten the two knurled locking screws on the module’s front panel.
Figure 1-2. Installing a Module
To Next Page
Loading...
Need help?
General
