1-15
Installing the 86100C
Step 7. Change removable hard disk (Option 86100C-090)
Step 7. Change removable hard disk (Option 86100C-090)
If your instrument includes Option 86100C-090, you must repeat the Windows
XP Setup Wizard procedure for the second, identical hard disk. The removable
hard disk option, 86100C-090, is designed for 86100C instruments that are
used in a secure environment. For more information, refer to “To use the
removable hard disk option” on page 1-28.
1 Turn off the 86100C.
2 Locate the hard disk lock, which is located at the upper-left corner of the
86100C's rear panel.
3 Insert one of the supplied keys into the hard disk lock, and turn the key counter
clockwise to unlock the hard disk.
NOTE Identical locks and keys are provided for all removable hard disks. The lock
mechanically secures the disk and is not intended for security purposes.
4 Press the button that is located beneath the lock, and pull out the hard disk.
5 Install the alternate hard disk. Make sure that the hard disk is oriented so that
the connector on the hard disk lines up with the connector in the mainframe.
6 Turn the key clockwise to lock the hard disk.
7 Repeat “Step 6. Windows Setup Wizard” on page 1-11 with the new hard disk.
8 Continue with “Step 8. Calibrate the touch screen” on page 1-16.
To Next Page
Loading...
Need help?
General
