Rockwell Automation Publication 6000-IN006F-EN-P - March 2018 45
Appendix A
Pre-Commissioning
Pre-Commissioning
Responsibilities
Rockwell Automation manages the start-up service for each installed drive at the
customer’s site, but there are a number of tasks the customer or its representatives
must complete before scheduling Rockwell Automation personnel for drive
commissioning.
Review this information prior to commissioning the drive as a reference for drive
line-up commissioning. Record the information in the data sheets provided;
these are useful during future maintenance and troubleshooting exercises.
Inspection and Verification
Before the drive commissioning occurs, Rockwell Automation recommends that
the customer arranges a pre-installation meeting to review:
a. the start-up plan
b. the start-up schedule
c. the drive(s) installation requirements
d. the pre-commissioning checklist
Customer personnel must be on-site to participate in the system start-up
procedures.
See Safety and Codes
on page 23.
ATTENTION: Perform the pre-commissioning tasks in the order listed in this
chapter. Failure to do so may result in equipment failure or personal injury.
Rockwell Automation requests a minimum of four weeks’ notice to schedule
each start-up.
ATTENTION: The CMOS devices used on the control circuit boards are
susceptible to damage or destruction by static charges. Personnel working near
static sensitive devices must be appropriately grounded.
To Next Page
Loading...
Need help?
General
