Allen-Bradley PowerFlex 6000T Hardware Service Manual

Rockwell Automation Publication 6000-TG100A-EN-P - September 2020 29
Chapter 3 Component Inspection and Test Procedures
Replace Filter for A-Frame Drives
1. Unlatch the thumbscrews and remove the air filter frame.
2. Remove and clean the cotton filter, or replace with a new cotton filter.
3. Close the air filter frame and tighten thumbscrews.
Figure 4 - Replace the Filter, A-Frame
Replace Filter for B-Frame Drives
1. Unlatch and open the cabinet filter door more than 90°.
Figure 5 - Replace the Filter, B-Frame
2. Remove the screens by pulling up out of the door.
IMPORTANT
When removing the filter, prevent accumulated dirt on the inlet side of
the filter from being sucked into the drive. It may be difficult to remove
the filter material without tearing due to the suction at the air inlet.
Thumbscrew Air inlet frame Cotton filter
Screw
Cotton filter
Air inlet frame
IMPORTANT
When removing the filter, prevent accumulated dirt on the inlet side of
the filter from being sucked into the drive. It may be difficult to remove
the filter material without tearing due to the suction at the air inlet.

Allen-Bradley PowerFlex 6000T Specifications

General

Brand	Allen-Bradley
Model	PowerFlex 6000T
Category	DC Drives
Language	English