AMX AXB-TPI/3 User Manual

Installation
5
AXB-TPI/3 Touch Panel Interface 3
Installation
The mounting brackets can be rotated 90° in any direction to accommodate several different
mounting options, including standard 19" (48.26 cm) equipment rack mounting, tabletop, under/
over the table, and vertical wall mounting.
Installing the Input Modules
1. Disconnect the power supply from the TPI/3.
2. Discharge the static electricity from your body by touching a grounded metal object.
3. Disconnect all connectors from the AXB-TPI/3.
4. Gently insert the module into the brackets inside the card slot and slide the input module into
the enclosure until you feel it contact the slot connector, as shown in FIG. 2.
5. Screw in (clockwise) the two thumbscrews to secure the each module.
6. Repeat steps 4 and 5 to insert other input modules, if necessary.
7. When you are done installing the input modules, reconnect all connectors, and apply power.
Removing Input Modules
1. Disconnect the power supply from the TPI/3.
2. Discharge the static electricity from your body by touching a grounded metal object.
3. Disconnect all connectors from the TPI/3 input module.
4. Remove (counter-clockwise) the two black thumbscrews on the input module.
5. Slide the module out of the enclosure.
Always power down the TPI/3 before attempting to remove or install input modules.
Failure to do so could result in damage to the TPI/3 and/or input modules.
FIG. 2 Inserting an input module
Always power down the TPI/3 before attempting to remove or install input modules.
Failure to do so could result in damage to the TPI/3 and/or input modules.

AMX AXB-TPI/3 Specifications

General

Brand	AMX
Model	AXB-TPI/3
Category	Recording Equipment
Language	English