Introduction
6
MVP-5100/5150 5.2" Modero Viewpoint Touch Panels
Product Specifications
The MVP-5100 differs from the MVP-5150 in that it does not have a built-in wireless
card or the capacity to install one, and only communicates with other devices via IR.
Otherwise, the two devices are identical.
MVP-5100 Specifications (FG5966-08)
Dimensions: 4 3/4" x 7 9/16" x 13/16" (120.7 mm x 191.8 mm x 20.3 mm)
Weight: • 1.25 lbs (0.57 kg)
Enclosure: Matte black plastic.
Power Requirements
(Without Charging):
Panel with battery fully charged:
• Constant current draw: 0.3 A @ 12 VDC
• Startup current draw: 0.4 A @ 12 VDC
Power Requirements
(While Charging):
Panel while charging battery:
• Constant current draw: 1.1 A @ 12 VDC
• Startup current draw: 1.3 A @ 12 VDC
Minimum Power Supply
Required:
• PS3.0 Power Supply (FG423-30) - both 120 VAC and 240 VAC models are
shipped with this power supply
Power Modes: • AWAKE: All necessary modules are powered up and device remains online
with the NetLinx Master.
• SLEEP: Only the backlight will be turned off after the user selectable time of
inactivity has elapsed. Panel resumes the On Mode in ~ 1 second upon a
momentary press of the touchscreen.
• STANDBY: Power to all components other than the touch screen is turned off
after the user selectable time of inactivity has elapsed. Device will turn back
on by touching the screen. Re-acquiring an AP connection may require up to
10 seconds.
• SHUTDOWN: Power to all peripherals and components is turned off. The
system remains in this mode until it is rebooted. The panel is re-activated by
pressing the touchscreen and holding until the AMX splash screen appears.
Battery Duration: • 18 hours of normal use, in a combination of On, Sleep, and Shutdown
Modes.
• Ten hours of continuous use (continuous On state).
Certifications: • IEC60950
•RoHS
• TELEC
• Lithium polymer microbattery: UN/IATA
Memory: • 128 MB Mobile DDRAM (upgrade not available)
• 256 MB NAND Flash (upgrade not available)
To Next Page
Loading...
Need help?
General
