use and maintenance MX 125
74
CHECKING AND CLEANING
THE TERMINALS
Carefully read p. 73 (BATTERY).
◆
Remove the left side cover, see pag. 58
(REMOVING THE SIDE COVERS).
◆
Make sure that the cable terminals (1)
and the battery terminals (2) are:
√ in good conditions (and not corroded
or covered with deposits);
√ covered with special grease or
Vaseline.
If necessary:
◆
Remove the battery, see beside
(REMOVING THE BATTERY).
◆
Eliminate any sign of corrosion with a
wire brush.
◆
Reconnect first the positive (+) and then
the negative cable (√).
◆
Cover the terminals with special grease
or Vaseline.
◆
Reinstall the battery, see p. 57
(INSTALLING THE BATTERY).
REMOVING THE BATTERY
Carefully read p. 73 (BATTERY).
◆
Make sure that the ignition switch is in
position ≈
∆.
◆
Remove the left side cover, see pag. 58
(REMOVING THE SIDE COVERS).
◆
Unscrew and remove the screw (3) from
the negative terminal (√).
◆
Move the negative cable (√) (4) sidewards.
◆
Unscrew and remove the screw (5).
◆
Remove the cover (6).
◆
Partially remove the battery from its
compartment.
◆
Unscrew and remove the screw (7) from
the positive terminal (+).
◆
Move the positive cable (+) (8) sidewards.
◆
Withdraw the breather pipe(9).
WARNING
Once it has been removed, the battery
must be stored in a safe place and kept
away from children.
◆
Remove the battery from its compartment
and put it on a flat surface, in a cool and
dry place.
To Next Page
Loading...
Need help?
General
