Switching on the opposite side turn indicators without pressing the switch in the in-
termediate reset position causes both the time and distance counters to reset and
recommence from zero.
02_106
High/low beam selector (02_106)
In DRL ON mode:
•
the DRL lights only are lit when the selector is left in the centre position (2).
•
pressing the selector into position (1) switches on the high beam headlight
•
press the selector into position (3) to flash the high beam headlamp to signal
danger or an emergency.
When the low beam headlights are on (DRL OFF):
•
the low beam lights only are lit when the selector is left in the centre position
(2).
•
pressing the selector into position (1) switches on the high beam headlight
•
press the selector into position (3) to flash the high beam headlamp to signal
danger or an emergency.
02_107
Passing button (02_107)
Press button (3) to flash the high beam headlamp to signal danger or an emergency.
Releasing the switch deactivates the high beam flash.
82
To Next Page
Loading...
Need help?
General