91
General Maintenance
Tires
Always use the size and type of tires specied for your ARGO ATV. Refer to the
specications chart in this manual for tire-related information and always maintain
proper tire ination pressure.
WARNING
The use of worn-out tires on your ATV can be dangerous and can increase the risk of
an accident.
WARNING
Tire Replacement
This ATV has low-pressure tubeless tires. Air is sealed by the contact surfaces of the inner
rim and the tire bead. If either the inner rim or tire bead are damaged, air may leak. Be
extremely careful not to damage these areas when replacing tires. It is very important to
use the proper tools when repairing or replacing tires to prevent damage to the tire, the tire
bead or the rims. If you do not have access to the proper tools or lack the technical ability,
have your tires serviced by an authorized ARGO dealer.
When breaking the tire bead loose from the rim, be extremely careful not to
damage the inner rim surface or the tire bead.
CAUTION
Use only ARGO approved tires on your ATV when replacing tires. Failure to do so
could result in unstable ATV operation.
WARNING
Mufer / Spark Arrester
The muer on this ATV is equipped with a spark arrester which must be periodically
cleaned. Refer to the intervals listed in the Maintenance Schedule and clean the spark
arrester using the procedure listed below.
Before service, wait for the muer to properly cool to avoid possible burns.
WARNING
1. Remove the three cap screws (1) securing the spark arrester assembly to the
muer; then remove the spark arrester (2) and the gasket (3) from the muer.
2. Using a suitable brush, clean the carbon deposits from the screen, taking care
to not damage the screen.
NOTE: If the spark arrester screen or gasket is damaged in any way, they must
be replaced.
3. Install the spark arrester assembly and secure with the cap screws.
Tighten securely.
To Next Page
Loading...
Need help?
General
