3.6 Web server
All controllers have a built-in web server that allows direct connection to the company network or
to a dedicated PC via a local area network (LAN). This allows to consult certain data and settings
via a PC instead of the display of the controller.
Getting started
If the unit is equipped with a SMARTBOX, the network connection of the controller is
already in use. To allow the web server functionality, the network cable that is
connected to the SMARTBOX should be unplugged and replaced by the cable of the
company network.
If both the web server functionality and SMARTBOX are required, please contact your
local Customer Center for support.
Make sure you are logged in as administrator.
• Use the internal network card from your computer or a USB to LAN adapter.
• Use a UTP cable (CAT 5e) to connect to the controller (see picture below).
Configuration of the network card
• Go to Network and Sharing Center (1).
• Click on Change adapter settings (1).
Instruction book
34 APF221384
To Next Page
Loading...
Need help?
General
