3.9 Quick look at the actual compressor status
Procedure
Control panel
Starting from the Main screen (see section Main screen menu), press the arrow down key (3): A screen
similar to the one below appears:
Example of the compressor status screen
‘Auto Operation’
‘Local Control’
‘Timer Active’
‘Main’ ‘Help’ ‘Xtra’
F1 F2 F3
Line 1 indicates the automatic or manual operation status of the regulator: ‘Auto Operation’ means that the
regulator automatically adapts the operation of the compressor, i.e. loading, unloading, stopping and
automatic restarting according to the programmed parameters.
Line 2 indicates whether the regulator is operating in local control or remote control mode: ‘Local Control’
means that the start/stop buttons on the keyboard are activated. ‘Remote Control’ means that these
functions are controlled remotely.
Line 3 indicates whether the timer which generates time-based start and stop commands is activated or not.
Press the arrow down key (3) to get other data (actual condition of the compressor). See section Control
programs.
Instruction book
32 API603130
To Next Page
Loading...
Need help?
General
