- 68 -
9.5.2 Oil drain pump
The oil drain pump facilitates oil change.
9.5.3 Undercarriage (axle, towbar,
towing eyes)
The undercarriage is equipped with an adjustable or
fixed towbar with DIN-eye, AC-eye, IT-eye, GB-eye,
NATO-eye or ball coupling and with road
signalisation which is approved by EC legislation.
When using this option
– Make sure that the towing equipment of the
vehicle matches the towing eye before towing the
generator.
– Never move the generator while electrical cables
are connected to the unit.
– Always apply the hand brake when parking the
generator.
– Leave enough space for operation, inspection and
maintenance (at least 1 meter at each side).
To maintain the undercarriage
– Check the tightness of the towbar bolts, the axle
bolts and the wheel nuts at least twice a year and
after the initial 50 hours of operation.
– Grease the wheel axle suspension bearings, the
drawbar to the steering gear shaft and the spindle
of the brake handle at least twice a year. Use ball
bearing grease for the wheel bearings and graphite
grease for the drawbar and spindle.
– Check the brake system twice a year.
– Check the condition of the vibration dampers
twice a year.
– Repack the wheel hub bearings once a year using
grease.
9.5.4 Galvanized skid with forklift
slots
To be able to lift the generator by means of a forklift,
a galvanized skid with rectangular slots is provided.
9.5.5 Hot parts protection (CE
compliance)
The hot parts protection shields hot parts of the genset
(turbo and exhaust system) to reduce the risk of burns.
9.5.6 Rotating parts protection (CE
compliance)
The rotating parts protection shields rotating parts of
the genset.
To Next Page
Loading...
Need help?
General
