The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using it for any purpose other than the
use of the products or the execution of the project to which it refers, and from communicating it to third parties without Automatic Systems’ prior written agreement.
Document subject to change without notice.
MOVING OBSTACLE
The passage obstacle consists of 2 mobile obstacles (7, Chapters 3.5.1. , 3.5.2. & 3.5.3. ) that cancel each
other completely along the unit in the open position, leaving the lane completely free.
To exclude any hazards for the user, the mobile obstacles are made of safety glass with rounded edges (no
sharp edges).
The torque applied during closing is less than prescribed by the applicable safety standards, so that the
obstacle can be stopped by the user without any major impact (even in the case of children).
The obstacles never close when a person is detected in front of them (safety zone).
The gaps between the obstacles and the unit are reduced to a minimum to prevent fingers being caught and
unwanted objects ending up inside the unit.