Commissioning
50 ─── Version: 2.1AS2000
Commissioning
Observe the operating instructions for the stepper motor ter-
minals and stepper motor modules
For commissioning, read the operating instructions for stepper mo-
tor terminals and stepper motor modules .Then perform the steps
according to the commissioning instructions.
Commissioning example
The procedure for commissioning is described as an example. A
different method may be appropriate or necessary, depending on
the application of the components.
Before commissioning
• Check drive for damage
• Check installation and alignment
• Tighten screw connections correctly
• Installing mechanical, thermal and electrical protective devices
• Check the wiring, connection and proper earthing of the drive
and stepper motor terminal
• Check emergency stop functions
During commissioning
• Make sure that all fittings were checked for function and adjust-
ment
• Observe information for environment and operation
• Check protective measures against moving and live parts
Configuration
Beckhoff recommends the use of stepper motor terminals and mo-
tors from Beckhoff in combinations and configuration in the Beckhoff
TwinCAT DriveManager.
Carry out the operating procedures in the operating instructions for
stepper motor terminals:
• Build Project and Choose Target System
• Implement devices by scanning or manually
• Configure devices, determine and set motor type
• Create axis configuration
• Set scaling factor and speeds
• Check status and activate control system
To Next Page
Loading...
Need help?
General
