Bitzer CM-SW-01 User Manual

SG-150-1 5
1.1 Reference guide
Before installation, the user should be thoroughly familiarized with this reference guide,
especially with purposes, installation and operation.
Special care should be taken when installing and connecting external equipment (PTC sensor,
high voltage etc.) and handling the modules correctly according to protection against ESD (Electro
Static Discharge).
Installation of the CM-SW-01 must be performed by authorized personnel only. All warranties
are excluded in case installation is performed by unauthorized personnel or in case the CM-
SW-01 has not been correctly installed.
1.2 Safety
The CM-SW-01 is a protection device and not a safety component according to the Machinery
Directive and cannot be used in “medical” or “life support” equipment
Before commissioning, the service technician shall ensure that personal safety requirements are
met in conformity with the Machinery Directive and local legislation based on safety estimations.
Electrical plant failures are to be immediately solved, even though no immediate danger exists;
the CM-SW-01 and motor must be without power.
Before soldering or welding on the compressor, all connections on the CM-SW-01 must be
secured against overvoltage!

Bitzer CM-SW-01 Specifications

General

Brand	Bitzer
Model	CM-SW-01
Category	Control Unit
Language	English