terminal of the donor vehicle's
battery.
Run the engine of the donor
vehicle during jump-starting.
Start the engine of the vehicle
with the discharged battery
in the usual way; if the en-
gine does not start, wait a few
minutes before repeating the
attempt in order to protect the
starter motor and the donor
battery.
Allow both engines to idle for a
few minutes before disconnect-
ing the jump leads.
Disconnect the jump lead from
the negative terminal and the
ground point first, then dis-
connect the second jump lead
from the positive terminal and
the positive battery connection
point.
NOTICE
Do not use proprietary start-as-
sist sprays or other products to
start the engine.
Installing side panel ( 122).
Diagnostic connector
Disengaging diagnostic
connector
Requirement
The diagnostic connector is
underneath the front right side
panel.
NOTICE
The diagnostic connector for on-
board diagnostics may only be
released by Service or a work-
shop working in accordance with
the vehicle manufacturer's spe-
cifications with correspondingly
trained personnel and used by
other authorised persons; the use
can otherwise lead to the vehicle
malfunctioning.
Remove the side panel
( 121).
Press in retainers 1.
Disengage diagnostic con-
nector 2 from holder 3.
The interface to the diagnosis
and information system can
be connected to diagnostic
connector 2.
8
127
z
Maintenance
https://www.motorcycle-manual.com/
To Next Page
Loading...
Need help?
General
